|
Preparation of Materials:
|
1. Clean and set up your workspace with all the materials listed above.
2. Label your test tubes or beakers for identification. |
|
Preparation of Potato Samples:
|
3. Wash the potato and dry it.
4. On the chopping board, use the cork borer, scalpel or knife to cut the potato into small, equal-sized pieces (approximately 1 cm³). |
|
Preparation of Hydrogen Peroxide Solutions:
|
5. Using the graduated cylinder or pipette, measure and pour 10 ml of 3% hydrogen peroxide into each test tube or beaker.
|
|
Conducting the Experiment:
|
6. Add a single piece of potato to the first test tube containing hydrogen peroxide.
7. As soon as the potato is added, start the stopwatch. 8. Observe the reaction between the potato and hydrogen peroxide for 1 minute. 9. Look for bubbling or fizzing, indicating the release of oxygen gas. 10. Record your observations in detail, focusing on the intensity and duration of the bubbling. |
|
Repeat the Experiment:
|
11. For accuracy and consistency, repeat the experiment with fresh hydrogen peroxide and a new potato piece in the remaining test tubes or beakers
|
|
Recording Data:
|
12. In your lab notebook, create a table to record your observations for each test tube. Note the size of the potato piece, the amount of hydrogen peroxide used, the intensity of the reaction, and any other notable observations in observation table.
|
|
Clean up
|
Dispose of the potato pieces and hydrogen peroxide solution in the waste container. Clean and sterilize the test tubes, beakers, and other equipment used.
|
|
Test Tube
|
Amount of Hydrogen Peroxide (ml)
|
Size of Potato Piece (cm3)
|
Time Observed (S)
|
Initial reaction
|
Final Reaction
|
Notes / Additional Observations**
|
|
1
|
10
|
1
|
60
|
Rapid Bubbling
|
Slows Down
|
|
|
2
|
10
|
2
|
||||
|
3
|
10
|
3
|
||||
No comments yet.
Cheatography n. The art of mapping complex subjects into clear, instantly navigable reference guides.